To Replace The Ntc Unit; Figure 16-1 Securing The Ntc To The Ntc Mount - Sun Microsystems StorEdge 3900 Series Reference And Service Manual

4. Remove the four hinge screws from the left side of the NTC mount. It is advised
that you lay the NTC mount on a flat, stable surface to remove the NTC unit.
5. Note the position of the NTC in the mount. Remove the six nuts (three on either
side) of the brackets that secure the NTC. Remove the brackets and remove the
NTC.

To Replace the NTC Unit

1. Put the new NTC into position in the mount and replace the brackets. Put the six
nuts on the bolts and tighten them.
FIGURE 16-1
16-4 Sun StorEdge 3900 and 6900 Series 1.1 Reference and Service Manual • July 2002
Securing the NTC to the NTC Mount