Preparing For Service; Safety Requirements - Sun Microsystems StorEdge 3900 Series Reference And Service Manual

7
C H A P T E R

Preparing for Service

The Sun StorEdge 3900 and 6900 series storage systems are preconfigured with all
the FRUs installed in the configuration the customer specified. This chapter
describes the preparation to service the FRUs in the storage system.
This chapter contains the following sections:
"Safety Requirements" on page 7-1
"Removing and Replacing the Front Door" on page 7-2
"Removing and Replacing the Side Panel" on page 7-2
For each FRU, the tools and parts required to do the service are described in the
chapter.
7.1

Safety Requirements

Ensure that the voltage and frequency of the power outlet to be used match the
electrical rating labels on the subsystem.
Wear an antistatic wrist strap when handling any magnetic storage FRUs or
system boards.
Use only properly grounded power outlets.
Caution – You must read the Sun StorEdge 3900 and 6900 Series Regulatory and Safety
Compliance Manual before beginning any procedure in this manual.
Caution – Do not make mechanical or electrical modifications to the storage system.
Sun Microsystems is not responsible for regulatory compliance of modified cabinets.
7-1