Preliminary Steps; Connecting To The Storage Service Processor; To Connect An External Serial Terminal To The Storage Service Processor - Sun Microsystems StorEdge 3900 Series Reference And Service Manual

The following tools are required for the replacement of the Storage Service
Processor:
1/4-inch slotted screwdriver
Small wire tie
12.1

Preliminary Steps

1. Obtain as much site-specific information as possible.
2. Using the Storage Automated Diagnostic Environment, type the following path if
the Storage Service Processor is the master:
/var/opt/SUNWstage/DATA/rasagent.conf
This is a path to the setup information for the customer's configuration.
12.2 Connecting to the Storage Service
Processor
Instructions for making various connections to the Storage Service Processor are
included in this section. These include:
Connecting an external serial terminal to the Storage Service Processor
Gaining access to the Serial Port of the Storage Service Processor
Making an Ethernet terminal connection
Making an Ethernet connection to the console port of the Storage Service
Processor
To Connect an External Serial Terminal to the
Storage Service Processor
1. Connect the serial communications port of the terminal to the Serial Console port
of the Service Panel using the RJ45-DB9 DTE adaptor (part number 530-3100-01)
and a standard CAT5 cable (part number 530-2093-01).
12-2 Sun StorEdge 3900 and 6900 Series 1.1 Reference and Service Manual • July 2002