Sun Microsystems StorEdge 3900 Series Reference And Service Manual page 206

7. Start a telnet session to the new Sun StorEdge T3+ array.
# /bin/telnet Sun-StorEdge-T3+-name
login: root
Password:
T3B Release 2.01.00 2002/03/22 18:35:03 (192.168.0.40)
Copyright (C) 1997-2001 Sun Microsystems, Inc.
All Rights Reserved.
8. Set a password on the Sun StorEdge T3+ array if it has not already been done.
Note – For Sun StorEdge 3900 and 6900 series systems, all Sun StorEdge T3+ arrays
in a cabinet must use the same password. If one of the other arrays already has a
password set, you must use the same password for the new array.
:/:<1> passwd
OLD password:
NEW password: new password
NEW password (confirm): new password
:/:<2>
9. Type quit to exit the telnet session.
10. Type the following to transfer the syslog.conf file to the array:
msp0# ftp Sun-StorEdge-T3+-name
Connected to Sun-StorEdge-T3+-name.
220 192.168.0.40 FTP server ready.
Name (t3b0:root): root
331 Password required for root.
Password: password
230 User root logged in.
ftp> put /opt/SUNWsecfg/etc/syslog.conf /etc/syslog.conf
200 PORT command successful.
150 Opening ASCII mode data connection for /etc/syslog.conf
226 Transfer complete.
local: /opt/SUNWsecfg/etc/syslog.conf remote: /etc/syslog.conf
242 bytes sent in 0.00072 seconds (328.23 Kbytes/s)
> quit
11. Log in to the Storage Service Processor and use the runsecfg(1M) command to
start the character user interface.
14-6 Sun StorEdge 3900 and 6900 Series 1.1 Reference and Service Manual • July 2002
Return
Return