Table of Contents
Advertisement
8
C H A P T E R
Maintaining the Tape Library
This chapter describes how to clean and service various components of the tape
library. To help the tape library perform at a optimum level, you should perform the
preventive maintenance procedures described in this chapter.
Be sure to read through this chapter and the "Safety Agency Compliance" section at
the beginning of this manual before starting any of the procedures.
8.1
Cleaning the Front Door
Caution – To avoid scratching or marring the window, do not use abrasive cleaners,
abrasive cleaning implements, or harsh chemicals or solvents (for example, alcohol,
!
kerosene, or petroleum spirits) to clean the door.
Use the wet-wipe and dry-wipe cleaning packets provided with the tape library.
8.2
Cleaning Tape Drives
Clean the tape drive heads and tape paths after every 72 tape-motion hours with an
approved 8 mm cleaning cartridge. Depending on the operating environment, you
may need to clean the tape drive (CTS) more often.
1. Make sure a cleaning cartridge is installed in the fixed cartridge slot.
If not, install one.
8-1
Advertisement
Table of Contents
