To Add A Sun Storedge T3+ Array - Sun Microsystems StorEdge 3900 Series Reference And Service Manual

To Add a Sun StorEdge T3+ Array

For additional information about upgrading a Sun StorEdge T3+ array, refer to the
Sun StorEdge T3 and T3+ Array Installation, Operation, and Service Manual and the Sun
StorEdge 3900 and 6900 Series 1,1 Installation Guide.
1. Determine which Sun StorEdge T3+ array you are adding.
This refers to the position it occupies in the Sun StorEdge expansion cabinet.
2. Identify the MAC address for the new Sun StorEdge T3+ array.
The MAC address of the Sun StorEdge T3+ array can be found on a card inside the
front cover of the device.
3. Log in to the Storage Service Processor.
Refer to Section 12.3, "Servicing the Storage Service Processor With the Sun StorEdge
Remote Response Enabled" on page 12-7 for instructions on logging in to the Storage
Service Processor.
4. Incorporate the new MAC address into the /etc/ethers file on the Storage
Service Processor. See the ethers(4) man page for details. For example:
8:0:20:7d:93:7e Sun-StorEdge-T3+-name
5. Ensure that the RARP daemon (in.rarpd(1M)) is running on the Storage Service
Processor.
msp0# ps -eaf | grep rarpd
root 317 314
msp0#
If the daemon is not running, start it with the following command:
msp0# /usr/sbin/in.rarpd dmfe 1
6. Install the new Sun StorEdge T3+ array and power up the partner group.
0 Sep 28 ? 0:00 /usr/sbin/in.rarpd dmfe 1
Chapter 14 Servicing Sun StorEdge T3+ Arrays 14-5