Replacing The Front Bezel And Ear Caps; Removing The Front Bezel And Ear Caps - Sun Microsystems StorEdge 3000 Series Installation, Operation And Service Manual

d. Send the firmware binary to the controller:
In HyperTerminal, select "Send file." If you are not using Hyper, choose "Upload"
or "Send" (depending on the software).
When the firmware update is complete, the controller automatically resets itself.
7.6

Replacing the Front Bezel and Ear Caps

Some procedures require that you remove the front bezel and the small vertical
plastic caps on either side of the bezel that cover the rackmount tabs. These
rackmount tabs are often referred to as "ears."
7.6.1

Removing the Front Bezel and Ear Caps

1. Use the provided key to unlock both bezel locks.
2. Grasp the front bezel cover on both sides and pull it forward and then down.
Note – For many operations, including replacing disk drives, it is not necessary to
further detach the bezel, since dropping it down moves it sufficiently out of the way.
3. Press the right bezel arm (hinge) towards the left side to release it from the chassis
hole.
The left hinge also disengages.
4. Note the location of the chassis bezel holes on each ear.
5. Remove the plastic caps from the front left and right ears of the array.
Both plastic caps are removed in the same way.
a. Squeeze both sides of the cap at the top and the bottom.
b. Turn the cap toward the center of the array until it disengages and pull it free.
Chapter 7 Maintaining Your Array 7-23