Sun Microsystems StorEdge 3900 Series Reference And Service Manual page 104

Set Switch Port SL Mode Per Sun StorEdge T3+ Array (Sun StorEdge 3900
Series only)–Sets the switch ports associated with the specified Sun StorEdge T3+
array to SL mode. If you select on all ports in the corresponding zone on each
switch are set to SL mode. If you specify off the SL mode is cleared and the ports
are returned to the predefined configuration. The last two zones on a Sun
StorEdge 3960 system contain two Sun StorEdge T3+ arrays that cannot be
separated.
Busy SUN Switches
-------------------
NOTE : Currently NO Sun Switches are being configured.
Available Port Settings
1) SL Mode
2) Default Modes (F and TL)
3) Return
Select option above:> 1
Retrieving list of available Sun StorEdge T3+ Array(s).........
AVAILABLE Sun StorEdge T3+ Array(s)
1) t3b0
2) ALL
3) Return
Select option above:> 1
Setting SL mode on for ports associated with T3+:
Setting Port 1 on sw1a to SL mode
Setting Port 2 on sw1a to SL mode
Setting SL mode on for ports associated with T3+:
Setting Port 1 on sw1b to SL mode
Setting Port 2 on sw1b to SL mode
5-26 Sun StorEdge 3900 and 6900 Series 1.1 Reference and Service Manual • July 2002
t3b0.
t3b0.