Connector Terminal Electrical Requirements; Input Circuit; Fuses And Leds; Figure 3.7-2 Input Circuit - Hivertec motionCAT Series User Manual

3.7.4 Connector Terminal Electrical Requirements

The following table shows the electrical requirements of connector signals described in the table above.
DI32 connector
Per input

3.7.5 Input Circuit

(1) 12-24V is externally supplied to EXT-P. 5V cannot be used.
(2) When using sensors that require multiple power supply voltages, the voltage can be divided in
units of 8 bits.
(3) Fuses are provided by units of 8 bits.
680Ω
1.8KΩ
680Ω
1.8KΩ

3.7.6 Fuses and LEDs

This module is provided with a fuse for every unit of 8 bits to prevent burnout by overcurrent.
When a fuse blows, the corresponding P0 to P3 LED (Green) located above and below the connector goes
OFF.
(When a fuse blows, turn OFF the power and check the circuit. Then, turn ON the power after a while)
IN/
OUT
I Consumption current: Approximately 8mA/point
Table 3.7-3 Connector terminal electrical requirements
Fuse
1.8KΩ
1.8KΩ
Fuse

Figure 3.7-2 Input circuit

HM-DO320C
Fuse
Fuse
Fuse
Fuses for
Fuse
EXT-P0 to P3
Fuse
Fuse
Fuse
Fuse

Figure 3.7-3 Fuse and LED positions

Contents
EXT-Px
+24V power supply +24V電源
IN-01
IN-32
EXT-Gx
EXT-P0 LED
EXT-P1 LED
EXT-P2 LED
EXT-P3 LED
73
LEDs for EXT-P0 to P2
LED for EXT-P3