Table of Contents
Advertisement
Manual Configuration
The motionCAT series products come with the manuals shown below.
⚫
motionCAT series User's Manual <Introduction>
⚫
motionCAT series User's Manual <Operation>
⚫
motionCAT series User's Manual <Operation for each individual modules>
⚫
motionCAT series User's Manuals <Software>
motionCAT series User's Manual <Introduction>
This manual provides the following information.
(1) motionCAT installation
(2) motionCAT Master board
(3) motionCAT Slaves
(4) Installation
(5) Trial operation
(6) Accessories
(7) Glossary
(8) Connection examples
Contents in (1) and (7) are intended for all motionCAT system users. Make sure to read them before using
the product.
The other contents are mainly intended for developers in charge of the installation, connection, and wiring.
motionCAT series User's Manual <Operation>
This manual provides information required for software development common to all motionCAT series
products.
(1) Operation of each module
(2) Information on device
motionCAT series User's Manuals <Software for Windows>
These manuals provide instructions for using the software attached to each master.
(1) Software configuration
(2) Sample program
(3) Preparations for software
(4) Library function
(5) Driver function
(6) Information on ports
Accompanying Software
The following software for Windows is attached to the master board of the motionCAT series.
(1)
Device drivers for Windows
Program for operation checking, "Getting Started"
(2)
(3)
Sample program for Microsoft Visual Studio
Refer to the User's Manuals <Software> for the contents of the accompanying software.
8
Advertisement
Table of Contents
