Table of Contents
Advertisement
(2)
Mounting and demounting a slave on/off the DIN rail
With the slave hooked at
the edge of the rail, push
the unit toward the wall.
Mounting
Figure 4.1-4 Mounting and demounting a slave on/off the DIN rail
4.1.3 Installing on the Floor with Screws
(1)
How to install on the floor
As shown in the figure below, each frame features a hook slot and a screw hole. Fix the slave to the floor at
three points: the hook slot of the rightmost frame, and the hook slot and screw hole of the leftmost frame when
looked from above.
Frame
Remove the cover to drive the
screws.
Hook slots and
3.5 circular hole
<How to install on the floor>
The mount surface fits
along the wall surface.
Appearance of the mounted slave
Hook slot
Large:
8
Small:
3.5
First, drive M3 screws
through the hook slots.
Then, hook the slave onto
the screw.
Figure 4.1-5 How to install on the floor
101
Downward Fulcrum
Demounting (Using a
flathead screwdriver)
For a M3 screw
Large:
Small:
φ3.5
The leftmost frame is the
base frame.
<Base frame>
Push upward
8
3.5
Advertisement
Table of Contents
