Device Interface Cables; Installing With A Din Rail; Figure 4.1-2 Device Interface Cables; Figure 4.1-3 Din Rail Installation - Hivertec motionCAT Series User Manual

4.1.1 Device Interface Cables

Driver

4.1.2 Installing with a DIN Rail

(1) Installing a DIN rail
115mm
C
C
The slave is mounted on the DIN rail off-center.
(1) DIN rail installation position
Encoder connector
(1) Servo I/F cable
C
C
Motion slave
(2) Machine I/F cable
Sensor

Figure 4.1-2 Device interface cables

21mm 40mm
DIN 35 rail
(Number of
frames)

Figure 4.1-3 DIN rail installation

C
C
DIO slave
HMG-P1 HMG-P2
(2) (3)
As shown above, there is one or two DIN rail mounts
depending on the number of frames.
(2) Number of DIN rail mounts
100
The I/F cable input part of the DIO
slave is designed to provide signals,
power supply, and GND systems
compatible with e-CON sensors.
A set of 3 conductors is
available for one sensor.
Conductors 1 to 40
Conductors 41 to 80
(3) DIO I/F cable
HMG-P3 HMG-P4
(4) (5)