Starting "Getting Started; Figure 6.4-1 Start Screen - Hivertec motionCAT Series User Manual

6.4.3 Starting "Getting Started"

For HPCI-MCAT520M, start "tmct5204.exe".
For HM-GU00T, start "tgu00t04.exe".
When the application is started, it automatically detects the modules and displays a screen similar to that
shown below.
Make sure that the actually connected modules are correctly displayed on the screen.
If the information on connected modules is incorrect, there is a problem, such as a slave
without power supply, wrongly set module ID, and wrongly set communication settings
switch, which will prevent correct operation.
In this case, make sure to check the settings, connections, and power supply of each slave
again.
Module Selection TreeView
(Hereinafter "TreeView")

Figure 6.4-1 Start screen

Warning
114