Connector Signal Table; Figure 2.4-6 Receiving Terminal Wiring - Hivertec motionCAT Series User Manual

2.4.6 Connector Signal Table

(1) J1 Connector for USB communication (USB type B)
Pin
1 VBUS
2 D-
3 D+
4 GND
(2) J2 Connector for Motionnet communication (RJ45)
Pin
1 Resistance to frame ground
2 Resistance to frame ground
3 S+
4 Reserved
5 Reserved
6 S-
7 Resistance to frame ground
8 Resistance to frame ground
(3) P24-IN Module's DC 24V receiving terminal
● Connect +24V power supply to the receiving terminal.
● Match the connection polarity to the one indicated on the plug (24/G).
● Recommended wire material: AWG20 - 18 (0.5 to 0.9mm
● For fixing cables: Crimp tool YC-630 (JST)
Board-side post: B2PS-VH
Function
Table 2.4-4 USB type B (J1) connector signals
Function
Table 2.4-5 RJ45 (J2) connector signals
Housing: VHR-2N
Contact: BVH-41T-P1.1
A. Post B. Housing (Fixed to the contact)

Figure 2.4-6 Receiving terminal wiring

36
2
stranded wire)