Connections Between Components And Power Supply System Wiring; Power Supply System Wiring For Slaves; Figure 4.2-1 Power Receiving Terminals (Example Of Hmg 1-Axis Motion Slave, Hmg-P1); Figure 4.2-2 One Power Supply For A Slave - Hivertec motionCAT Series User Manual

4.2 Connections between Components and Power Supply System Wiring

4.2.1 Power Supply System Wiring for Slaves

(1) Single piece of slave
A slave is equipped with +24V power receiving terminals on the communication board and each of the
modules.
⚫ Connect the power receiving terminals to the +24V power supply.
⚫ Match the connection polarity to the one indicated on the plug (24/G).
⚫ Recommended wire material: AWG20 - 18 (0.5 to 0.99mm
⚫ For fixing cables: Crimp tool YC-630 (JST)
Power receiving
terminal on the
communication
board

Figure 4.2-1 Power receiving terminals (Example of HMG 1-axis motion slave, HMG-P1)

(2) Power supply system wiring for modules
+24V
power
supply
Board-side post: B2PS-VH
C
C
Power receiving
terminal on the
module
+
-

Figure 4.2-2 One power supply for a slave

2
stranded wire)
A. Post B. Housing (Fixed to the contact)
103
Housing: VHR-2N
Contact: BVH-41T-P1.1