Reconfiguring The Device With An Application Or Factory Image - Intel Agilex Configuration User Manual

4. Remote System Update (RSU)
UG-20205 | 2019.10.09
Related Information
rsu1.tcl

4.6.4. Reconfiguring the Device with an Application or Factory Image

The following steps describe the process to reconfigure the device with a different application image or the factory image
using operation commands after the device is in user mode.
1. The remote system update host sends the
new application image or factory image.
a. For example, in the Tcl console of the System Console, type the following command to initiate a remote system
update to the factory image.
i.
rsu_image_update 0x00110000
This command reconfigures the device with factory image. Address
factory image as shown in the
the device reconfiguration is successful. You must restart the System Console to re-establish the connection with
the device to perform next command.
ii.
rsu_image_update 0x002F4000
This command reconfigures the device with the application image. Address
the application image as shown in the
Optional: Retrieve the remote system update status by using the
reconfigured the device.
2. In the Tcl console of the System Console, type
device is being reconfigured with the factory image.
Send Feedback
command to perform the remote system update to the
RSU_IMAGE_UPDATE
file. The JTAG host automatically disconnects from the System Console once
.map
file.
.map
rsu_status
to verify the current image. The following figure shows the
rsu_status
is the start address of the
0x00110000
is the start address of
0x002F4000
command to ensure you have successfully
Intel ® Agilex ™ Configuration User Guide
171