Intel Agilex Configuration User Manual page 169

4. Remote System Update (RSU)
UG-20205 | 2019.10.09
Note: This example does not assign the Direct to Factory Image pin. Consequently, the Programmer configures the
device with the application image. The application image is the default image if the design does not use the Direct
to Factory Image pin.
5. Use the
RSU_STATUS
example:
a. In the Intel Quartus Prime software, select Tools
system console.
b. In the Tcl Console pane, type
update commands. Refer to the Related Information for a link to
c.
Type the
running image address from the remote system update status report. The current image address must match the
start address for the application image printed in the
Send Feedback
command to determine which bitstream image the Programmer is using as shown in the following
source rsu1.tcl
command to report the current remote system update status. You can retrieve the current
rsu_status
System Debugging Tools
to open the example of Tcl script to perform the remote system
rsu1.tcl.
file.
.map
System Console to launch the
Intel ® Agilex ™ Configuration User Guide
169