Intel Agilex Configuration User Manual page 156

Note: If unused space is not available, you can use an application image space other than application image 1. In this
case after the update operation completes you must restore the application image by writing the associated
application image (
Figure 64. Specifying Parameters for Single .rpd Stored in Flash Memory
7. By default, the
endian format, set Bit swap to On to generate the
8. On the Input Files tab, click Add Bitstream. Change the Files of type to SRAM Object File (
factory image
Intel ® Agilex ™ Configuration User Guide
156
) to the application slot.
.rpd
Specify Device Family
Specify Configuration Mode
Specify Output Directory
Specify Output File Name
Select Raw Programming Data
Specify Start Address in Flash
file type is little-endian. If you are using a third-party programmer that does not support the little-
.rpd
file and click Open.
.sof
file in big endian format.
.rpd
4. Remote System Update (RSU)
UG-20205 | 2019.10.09
Edit
). Then, select
*.sof
Send Feedback