As_Clk - Intel Agilex Configuration User Manual

If you use a third-party programmer to program an
of the serial flash device. If you use
configuration data starting from address 0 of the serial flash device.
3.2.7.1. Understanding Quad SPI Flash Byte-Addressing
At power-on the SDM operates from boot ROM. The SDM loads configuration firmware from Quad SPI flash using 3-byte
addressing. Once loaded, if the flash size is 256 Mb or larger, the SDM configures the Quad SPI flash to operate in 4-byte
addressing mode and continues to load the rest of the bitstream until configuration completes.
Intel Agilex devices support the following third-party flash devices operating at 1.8 V:
• Macronix MX66U 512 Mb, 1 and 2 gigabits (Gb)
• Macronix MX25U 128 Mb, 256 Mb, and 512 Mb
• Micron MT25QU 128 Mb, 256 Mb, 512 Mb, 1 Gb, and 2 Gb
Micron and Macronix both offer Quad SPI memories a density range of 128Mb—2Gb.

3.2.8. AS_CLK

The Intel Agilex device drives
pin generates
OSC_CLK_1
provide a 25 MHz, 100 MHz, or 125 MHz clock to the
Set the maximum required frequency for the
Configuration Software Settings
Table 28.
Supported configuration clock source and
Configuration Clock Source
Internal oscillator
OSC_CLK_1
Intel ® Agilex ™ Configuration User Guide
100
.rpd
or files, the Intel Agilex Programmer automatically programs the
.jic .pof
to the serial flash device. An internal oscillator or the external clock that drives the
AS_CLK
. Using an external clock source allows the
AS_CLK
OSC_CLK_1
pin in the Intel Quartus Prime software as described in
AS_CLK
on page 101. The
AS_CLK
Frequencies in Intel Agilex Devices
AS_CLK
, ensure that the configuration data is stored starting from address 0
to run at a higher frequency. If you
AS_CLK
pin, the can run up to 133 MHz.
AS_CLK
pin runs at or below your selected frequency.
AS_CLK
3. Intel Agilex Configuration Schemes
UG-20205 | 2019.10.09
Active Serial
Frequency (MHz)
25
58
77
115
25
50
continued...
Send Feedback