Intel Agilex Configuration User Manual page 173

4. Remote System Update (RSU)
UG-20205 | 2019.10.09
The
program_flash
a. The
.rpd
b. The start address.
c.
Number of words to write for each
instruction.
3. Write the new application image start address to a new image pointer entry in the configuration firmware pointer block
(CPB) using the
the write.
Note: You must update both copies (CBP0 and CBP1) when editing the configuration firmware pointer block and sub-
partition table. Refer to
Based on the example described above, the address offset
application image. The next new image pointer entry value must be
new application image to the next image pointer entry.
Send Feedback
function takes three arguments:
file to write to flash memory.
QSPI_WRITE
command. Ensure that the new image pointer entry value is
QSPI_WRITE
Table 1 for more details about the configuration firmware pointer block.
command. The supports up to 1024 words per write
QSPI_WRITE
in the CPB0 and CPB1 must point to the start address of the
0x20
before you write the start address of the
0xFFFFFFFF
before initiating
0xFFFFFFFF
Intel ® Agilex ™ Configuration User Guide
173