Power Up Base System; Configure Base Gps Receiver To Function As Rtk Base; Figure 4.4 Measuring Hi (Height Of Instrument) Of Base Gps Antenna - Thales Z-Max Operation And Application Manual

HI Measuring Plate
HI Measuring Tool

Figure 4.4 Measuring HI (Height of Instrument) of Base GPS Antenna

Power Up Base System

Power up the system by pressing the power button on the front panel of the GPS
Receiver Module. Power on the radio. (Note that the Thales Max UHF radio and the
Communication Module do not have a power button. The radio and the GSM modem
will power on during configuration.) Check that all components are powered up. The
GPS receiver and the PDL radio have an LED to indicate that power has been applied
and the component is on.

Configure Base GPS Receiver to Function as RTK Base

This task is usually accomplished using the handheld computer running the Field
Application software. However, the Z-Max base station can also be configured
through the front panel display. If you are using the handheld computer to configure
the base system, refer to the Field Application software documentation for specific
steps. If using the front panel of the Z-Max, refer to Chapter 4 of the Operations and
Reference section of this manual.
228 Z-Max Surveying System Operation and Applications Manual