Survey Configuration (Survconf) - Thales Z-Max Operation And Application Manual

Survey Configuration (SURVCONF)

In the SURVCONF menu, you select the desired survey mode and set initial survey
parameters. There are four possible survey modes:
Static
Kinematic
RTK Base
RTK Rover
To select a survey mode from the top level , press the ENTER key to enter the
SURVCONF menu and use the UP or DOWN control keys until MODE is displayed on
the screen. Press ENTER again and use the UP or DOWN control keys until the
desired mode is displayed. Press ENTER to select that mode.
Once the desired survey mode is selected, only the parameters relevant to that
choice will be available. Access these parameters by using the UP/DOWN control
keys. Complete the survey set up procedure by going to the SURVEY: mode menu.
Note that certain choices made in the SURVCONF screen will affect what parameters
and options are available in the SURVEY: mode menus.
SURVCONF:STATIC
Recording Interval (REC INI: ***.*s)
Displays and sets the data recording interval. To change this parameter press
the ENTER key and use the control keys to enter the desired value in
seconds. The default is 20 seconds. The valid range is 0.2 - 999 seconds.
Elevation Mask (ELEV MASK: **)
Displays and sets the data collection elevation mask. To change this
parameter press the ENTER key and use the control keys to enter the
desired value in degrees. The default is 10 degrees.
Mode (MODE: STATIC)
Displays and sets the selected survey mode. Change the survey type by
pressing the ENTER key and use the UP/DOWN control keys to choose the
desired survey mode. Press ENTER to select it. The mode selected will
determine the parameters displayed.
60 Z-Max Surveying System Operation and Applications Manual