Thales Z-Max Operation And Application Manual page 76

Current Position
(LAT: N/S ** ** **.***** LON:E/W *** ** **.***** ALT: *****.*** m)
This field displays the computed latitude and longitude in degrees,
minutes, and seconds, and the computed height above the ellipsoid in
meters.
PDOP (PDOP: **.*)
Displays the PDOP value for the current satellite constellation.
Number of Satellites Used (#USED: **)
Displays the number of satellites used in the position computation. If
the elevation mask is the same as the position elevation mask, then
this is also the number of satellites being recorded on the data card.
Time (CNT/GPS/UTC: **.**.**)
This screen displays the current time and will show one of three types
of time. CNT is the time since power up and is displayed until the
receiver first locks onto a satellite. GPS is GPS time and is displayed
between locking onto a satellite and until receiving UTC time
corrections. UTC is UTC time.
SURVEY: RTK BASE
The parameters displayed in SURVEY: RTK BASE are the following:
Site ID (SITE: ****)
Displays and sets the 4-character Site ID. To change the Site ID, press the
ENTER key and use the control keys to enter the desired site name.
Antenna Height (ANT HT: **.**** m)
Displays and sets the height of the antenna above the survey mark. To
change the antenna height, press the ENTER key and use the control keys to
enter the height. Valid range is from 0.00 - 64.0000 meters.
Antenna Radius (ANT RAD: *.**** m)
Displays and sets the radius of the antenna. To change this parameter, press
the ENTER key and use the control keys to enter the radius . Valid range is
from 0.00 - 9.9999 meters.
Entered Base Station Position (BASE POS)
Entry point to the submenu that allows you to enter the known accurate base
station position. To enter this submenu, press the ENTER key. The following
fields are now accessible:
Operation 53