Survey Parameters And Status (Survey:mode) - Thales Z-Max Operation And Application Manual

Survey Parameters and Status (Survey:mode)

The SURVEY: mode menu is used to set site-specific survey parameters, execute
surveys and view survey status parameters.
This menu tree is mode-dependent, meaning that the parameters displayed in this
submenu are dependent on the type or mode of survey selected in the Survey
Configuration (SURVCONF) screen. The default survey mode is STATIC. If a different
survey mode is desired, enter the SURVCONF menu to select the desired survey
mode and enter the initial parameters for that mode before returning to this menu and
setting parameters. There are 4 possible modes:
Static (default)
Kinematic
RTK Base
RTK Rover
To enter this menu from the top level of the menu tree, use the UP/DOWN keys until
'SURVEY: mode' is displayed, then press the ENTER key. The parameters displayed
and available will depend upon which survey mode has been set in the SURVCONF
menu. Use the UP/DOWN keys to scroll through the following parameters.
SURVEY: STATIC
The parameters displayed in SURVEY: STATIC are the following:
Site ID (SITE: ****)
Displays and sets the 4-character Site ID. To change the Site ID, press the
ENTER key and use the control keys to enter the desired site name.
Antenna Height (ANT HT: **.**** m)
Displays and sets the height of the antenna above the survey mark. To
change the antenna height, press the ENTER key and use the control keys to
enter the height. Valid range is from 0.00 - 64.0000 meters.
Vector Length (DESIRED VECTOR LENGTH: *** km)
Not implemented in this release.
Survey Status (STATUS)
This is the entry point to the submenu that displays the static survey status
parameters. To enter this submenu, press the ENTER key and the following
parameters are accessible:
Operation 51