Thales Z-Max Operation And Application Manual page 79

There are many parameters used to configure the RTK Rover. To improve useability,
the RTK Rover menu tree has been broken up into three levels. Level 1 sets the
antenna parameters, level 2 selects between manual or auto/trajectory data logging,
and level 3 accesses the parameters particular to the selection made in level 2. Some
of the parameters in level 3 are mode-dependent, meaning that the parameters
displayed will depend upon the parameters that were selected in the Survey
Configuration (SURVCONF) menu.
Each level will be described separately.
1st Level
The top level parameters displayed are the following:
Antenna Height (ANT HT: **.**** m)
Displays and sets the height of the antenna above the survey mark in meters.
Valid range is from 0.00-64.0000 meters. To change this parameter, press the
ENTER key. The default is 0.0 meters.
Antenna Radius (ANT RAD: *.**** m)
Displays and sets the radius of the antenna in meters. Valid range is from
0.00-9.9999 meters. To change this parameter, press the ENTER key.
Entry to Logging submenu (LOGGING)
Entry point to the second level of submenus. Press the ENTER key to reach
the 2nd level submenu.
2nd Level
The 2nd level submenu allows you to select between MANUAL and AUTO POINT if
the Auto Point option was selected as the LOG TYPE in the SURVCONF menu, or
between MANUAL and TRAJECTORY if the Trajectory option was selected as the
LOG TYPE in the SURVCONF menu. Selecting one of these options in the 2nd level
will take you automatically to the 3rd level. To enter the third level, use the UP/DOWN
control keys to select the desired RTK logging type and press ENTER. This selection
will take you to the 3rd level.
Manual Logging (MANUAL POINT)
Entry point to the submenus to set manual logging parameters and to execute
a Manual Point RTK survey. In a Manual Point survey, the user sets the site
name and monitors the elapsed time to determine when to end the site
occupation. To enter this level, press the ENTER key.
Automatic Logging (AUTO POINT)
Entry point to the submenus to set automatic logging parameters and to
execute an AUTO POINT RTK survey. In an AUTO POINT survey, the user
56 Z-Max Surveying System Operation and Applications Manual