Thales Z-Max Operation And Application Manual page 80

sets an initial site name and a 'time to stay;' parameter in the Survey
Configuration menu (SURVCONF). The receiver will collect data on each
point based on the 'time to stay' parameter and automatically increments the
Site ID by 1 at the end of the occupation. To enter this level, press the ENTER
key.
NOTE: The Site ID will automatically increment only if the last character is numeric.
Trajectory Logging (TRAJECTORY)
Entry point to the submenus to set trajectory logging parameters and to
execute a TRAJECTORY RTK survey. In Trajectory logging, the receiver will
compute RTK positions each time an interval of a certain distance has been
traversed. The Site ID will automatically increment each time RTK data is
logged to the receiver. The Distance Interval parameter is set in the Survey
Configuration menu (SURVCONF).
NOTE: The Site ID will automatically increment only if the last character is numeric.
3rd Level
The third level parameters allow you to set survey parameters, execute the survey,
and monitor accuracy for the type of data logging selected in level 2. Only the
parameters applicable to that logging type will be displayed. The possible data logging
modes are: AUTO POINT, MANUAL POINT, and TRAJECTORY.
MANUAL POINT
Site ID (SITE: ****)
Displays and sets the 4-character Site ID. To change the Site ID, press the
ENTER key and use the control keys to enter the desired site name.
Start Logging (START)
Initiates data logging at the site entered in the above Site ID field. Also, the
entry point to monitor accuracy parameters and to stop data logging. Press
the ENTER key to start data logging. The following parameters will be
available by using the UP/DOWN keys:
Time Elapsed (TE: ***s)
Displays the amount of time in seconds elapsed since data logging
began. The field will display up to 9999 seconds of data logging. This
field will not increment if no SD card is inserted.
Operation 57