Thales Z-Max Operation And Application Manual page 94

Send user selected parameters to the receiver. (PROGRAM)
Press the ENTER key to send your selected radio parameters (frequency,
channel) to the receiver. Any errors in sending the parameters will trigger a
warning message that will be displayed on the front panel.
Power off the radio. (PWR OFF)
This is NOT a power status indication for the radio, but a function to turn off
the radio in the Communication Module. It is required that the port needs to
be set to D before entering this field. Press the ENTER key to power off the
Thales radio.
COM OPTN: PDL RADIO
The PDL Radio menu is shown in Figure 4.6.
To access the PDL radio menu from COM OPTN, press ENTER and use the UP/
DOWN keys until PDL is displayed. Press the ENTER key to enter the submenu.
When the PDL radio submenu is entered, the PORT parameter is the first parameter
displayed. From this level, all other PDL radio parameters can be accessed by using
the UP key. To move back to a previous menu item, press the DOWN key. Press
CANCEL from any of the submenus to leave the PDL submenu.
When the PDL radio is in the Communication Module, the PORT and BAUD RATE
settings should be left at the default settings of Port D and 19200 baud.
NOTE: It is recommended that you configure the parameters in the order in which they are
displayed. In particular, you must load the radio parameters (LOAD) prior to sending user settings
(PROGRAM).
Operation 71