Thales Z-Max Operation And Application Manual page 75

Current Position
(LAT: N/S ** ** **.***** LON:E/W *** ** **.***** ALT: *****.*** m)
This field displays the computed latitude and longitude in degrees,
minutes, and seconds, and the computed height above the ellipsoid in
meters. The displayed position is either an autonomous or code-phase
differential position.
PDOP (PDOP: **.*)
Displays the PDOP value for the current satellite constellation.
Number of Satellites Used (#USED: **)
Displays the number of satellites used in the position computation. If
the elevation mask is the same as the position elevation mask, then
this is also the number of satellites being recorded on the data card.
Time (CNT/GPS/UTC: **.**.**)
This screen displays the current time and will show one of three types
of time. CNT is the time since power up and is displayed until the
receiver first locks onto a satellite. GPS is GPS time and is displayed
between locking onto a satellite and until receiving UTC time
corrections. UTC is UTC time.
SURVEY: KINEMATIC
The parameters displayed in SURVEY: KINEMATIC are the following:
Site ID (SITE: ****)
Displays and sets the 4-character Site ID. To change the Site ID, press the
ENTER key and use the control keys to enter the desired site name.
Antenna Height (ANT HT: **.**** m)
Displays and sets the height of the antenna above the survey mark. To
change the antenna height, press the ENTER key and use the control keys to
enter the height. Valid range is from 0.00 - 64.0000 meters.
Survey Status (Status)
This is the entry point to the submenu that displays the kinematic survey
status parameters. To enter this submenu, press the ENTER key and the
following parameters are accessible:
52 Z-Max Surveying System Operation and Applications Manual