Thales Z-Max Operation And Application Manual page 62

of satellites visible can be determined with the Mission Planning module of
the GNSS Studio software.
Data Recording
To verify that data is being recorded to the SD Memory Card:
1. Check the Data Log LED.
2. Within 5 minutes of the completion of an initialization, the Data Log LED
should blink green once every 20 seconds, indicating that data is being
recorded to the SD Memory Card at the default rate of once every 20
seconds. If the Data Log LED is not blinking or is solid red check the
memory status menu.
Memory/Battery Status
To check for remaining memory and battery time available:
1. If the front panel display is in sleep mode (nothing is displayed) press any
of the display control buttons.
2. If SYSINFO is not displayed, press the up arrow button (
submenu SYSINFO is visible on the Display.
3. Press the Enter button (
4. Press the up arrow button (
MEM: **% is seen on the Display. The MEM function displays the memory
left on the SD Memory Card as a percent of the total memory.
5. Press the up arrow button (
Display. The BAT function displays the amount of battery time left in
minutes.
6. Press the Cancel button (K) to return to the top level of the menu tree.
Getting Started
) to enter the SYSINFO submenu.
G
) to scroll through the options until the function
G
) until the function BAT: **min is seen on the
C
) until the
39