Thales Z-Max Operation And Application Manual page 84

SURVCONF: KINEMATIC
Epoch Counter (EPOCH COUNTER: ***)
Displays and sets the value of the epoch counter. The epoch counter is the
number of epochs that will be recorded at each point every recording interval.
When the epoch counter counts down to 0, the Site ID (SITE) is automatically
reset to question marks ("????"). Reset the epoch counter by entering a new
Site ID. To change this parameter, press the ENTER key, use the control keys
to enter a value and press ENTER to select it.
Minimum Number of Satellites (MIN SV: *)
Displays and sets the minimum number of satellites required to perform a
kinematic survey. If the number of locked satellites falls below this number,
the receiver will issue a warning message and an alarm (beep) indicating that
you must return to the last known point. To change this parameter, press the
ENTER key, use the control keys to enter a value, and press ENTER to select
it. The default is 0 (alarm disabled).
Recording Interval (REC INI: ***.*s)
Displays and sets the data recording interval. To change this parameter press
the ENTER key and use the control keys to enter the desired value in
seconds. The default is 20 seconds. The valid range is 0.2 - 999 seconds.
Elevation Mask (ELEV MASK: **)
Displays and sets the data collection elevation mask. To change this
parameter press the ENTER key and use the control keys to enter the desired
value in degrees. The default is 10 degrees.
Mode (MODE: KINEMATIC)
Displays and sets the selected survey mode. Change the survey type by
pressing the ENTER key and use the UP/DOWN control keys to choose the
desired survey mode. Press ENTER to select it. The mode selected will
determine the parameters displayed.
SURVCONF:RTK BASE
Port and Type (PORT/TYPE)
Displays and sets the RTK data link port and data type. The receiver will
transmit the selected data type via the selected port. The data link (radio or
GSM) must be connected to this port.
Operation 61