Figure 2.4 Front Panel Display And Control Keys - Thales Z-Max Operation And Application Manual

Data Log LED
The Data Log LED will blink green each time GPS measurement data is recorded
to memory. The LED will blink at the frequency of the Recording Interval setting
(20 seconds by default). If the SD card fills up and is unable to log any more data
to memory, the LED will go to constant red. To free up space on the SD card, see
the SESSIONS submenu of the Front Panel User Interface in Chapter 4 on
page 66.
Satellite/Power LED
After power up, the Satellite/Power LED will continue to blink red once every 1-2
seconds to indicate that the unit is powered on. Between each red blink, the LED
will also blink green once for each satellite that the receiver is tracking.
Front Panel User Interface
Below the LEDs is the Front Panel User Interface (Figure 2.4). The interface is an 8-
character, scrolling alphanumeric LED display that allows you to monitor receiver
status, set receiver parameters and configure the receiver to perform different types of
surveys. You can check for available memory and battery life, save parameters, and
configure the data links for RTK surveys. The display also shows warning messages
and equipment status messages.

Figure 2.4 Front Panel Display and Control Keys

Equipment Description 13