Thales Z-Max Operation And Application Manual page 77

Latitude (LAT: N/S dd mm.mmmmmm)
To enter the base station latitude, press ENTER and use the control
keys to enter the latitude in degrees and decimal minutes.
Longitude (LON:E/W ddd mm mmmmmm)
To enter the base station longitude, press ENTER and use the control
keys to enter the latitude in degrees and decimal minutes.
Ellipsoidal Height (ALT: *****.** m )
To enter the base station height, press ENTER and use the control
keys to enter the ellipsoidal height in meters.
Set to current position. (HERE)
HERE will set the base station position to the current computed
position. To set this position, press ENTER. The query "Set Current
Position to Base?" appears. Press ENTER to confirm or CANCEL to
cancel.
Survey Status. (STATUS)
This is the entry point to the submenu that displays the status parameters
current position, PDOP, number of satellites, and time. To enter this
submenu, press the ENTER key and the following parameters are accessible:
Current Position
(LAT: N/S ** ** **.***** LON:E/W *** ** **.***** ALT: *****.*** m)
This field displays the computed latitude and longitude in degrees,
minutes, and seconds, and the computed ellipsoidal height meters.
The displayed position is either an autonomous or code phase
differential position.
PDOP (PDOP: **.*)
Displays the PDOP value for the current satellite constellation.
Number of Satellites Used (#USED: **)
Displays the number of satellites used in the position computation. If
the elevation mask is the same as the position elevation mask, then
this is also the number of satellites being recorded on the data card.
Time (CNT/GPS/UTC: **.**.**)
Displays the current time and will show one of three types of time. CNT
is the time since power up and is displayed until the receiver first locks
onto a satellite. GPS is GPS time and is displayed between locking
onto a satellite and until receiving UTC time corrections. UTC is UTC
time.
54 Z-Max Surveying System Operation and Applications Manual