Thales Z-Max Operation And Application Manual page 113

Warning
Not Receiving RTCM Base
Data
Bad Base Coordinates
Bad RTCM Base Position
Int. Battery Error:
SMBus
Int. Battery Error: Access
Low Int. Battery: < 10 min
Low Int. Battery: < 30 min
Low Backup Battery
† Memory Test Error:
RAM
† Memory Test Error: BBRAM
† Memory Test Error: ROM
† Memory Test Error: BOOT
No Data Card Detected
90
Table 4.6. Warning Messages (continued)
Definition
Not receiving RTCM code phase
corrections from the base
receiver.
The position entered in the base
receiver for CPD operation is not
correct (too far from the computed
position).
The position entered in the base
receiver for RTCM code operation
is not correct (too far from the
computed position).
BATTERY WARNINGS
The SMBus control for the inter-
nal battery communication is not
working.
Can't access the internal battery.
Remaining life of internal battery
is < 10 minutes.
Remaining life of internal battery
is < 30 minutes.
The internal battery that powers
the non-volatile memory and the
real-time clock is low and needs
to be changed.
MEMORY WARNINGS
Error with RAM
Error with battery backed up
memory.
Error in the ROM (flash).
Error with boot section of flash
SD MEMORY CARD WARNINGS
The SD memory card is either
missing or not properly inserted
and has not been detected; no
data recording will be done.
Z-Max Surveying System Operation and Applications Manual
Action
Check serial/data link with the base.
Ensure base is computing a position.
Ensure a valid position was entered
into the base receiver.
Enter the correct base position.
Enter the correct base position.
Remove Power Module and reinsert
it.
Remove Power Module and reinsert
it.
Change Power Module, or attach
external battery.
Change Power Module, or attach
external battery.
Contact Customer Support. Backup
battery must be replaced.
Perform a receiver initialization.
Perform a receiver initialization.
Perform a receiver initialization.
Perform a receiver initialization.
Insert or re-insert SD memory card.