Selecting A Magazine - Siemens SINUMERIK 840D sl Operating Manual

Tool management
7.2 Tool list
Unloading tools
7.2.7

Selecting a magazine

You can directly select the buffer memory, the magazine, or the NC memory.
Proceed as follows
116
1. Place the cursor on the tool that you would like to unload from the
magazine and press the "Unload" softkey.
2. Select the required load point in the "Load point selection" window.
3. Confirm your selection with "OK".
- OR -
Undo your selection with "Cancel".
1. Select the "Parameter" operating area.
2. Press the "Tool list" softkey.
3. Press the "Magazine selection" softkey.
If there is only one magazine, you will move from one area to the next
(i.e., from the buffer memory to the magazine, from the magazine to
the NC memory, and from the NC memory back to the buffer memory)
each time you press the softkey. The cursor is positioned at the
beginning of the magazine each time.
- OR -
Operating Manual, 11/2006, 6FC5398-6AP10-1BA0
HMI sl Universal