Electronic Key Re-Registration Using The One-Time Dongle - Toshiba e-STUDIO6520C Service Handbook

7.2.9

Electronic key re-registration using the one-time dongle

[A] When the board is replaced
The Electronic key registered using the one-time dongle can be re-registered only in the same
equipment. When the SYS board or SRAM board (for SYS board) is replaced, follow the procedures for
re-registration given below.
(1) After the SYS board or SRAM board is replaced, set up the equipment referring to the following
procedures.
P.7-27 "7.2.4 Precautions and Procedures when replacing the SYS board"
P.7-29 "7.2.6 Precautions and Procedures when replacing SRAM board (for SYS board)"
(2) Perform 08-3840 with the one-time dongle previously used for registering the Electronic key.
P.7-27 "[D] Reinstall options"
P.7-32 "[J] Reinstall options"
(3) When the authentication succeeds, the re-registration screen appears and the available
reregistration numbers are displayed after the option names.
(4) Perform the registration in the same manner as a regular one.
Note:
This procedure is available only with the one-time dongle used for the previous registration, since
the model information registered in it is utilized. Use the same one-time dongle and the
equipment when registering the Electronic key.
[B] When the equipment is replaced due to malfunction
When the equipment has to be replaced due to a malfunction, return the Electronic key registered in the
equipment to the one-time dongle and register it to the new equipment following the procedure below.
Note:
The Electronic key of the IPSec option (GP-1080) cannot be re-registered.
(1) Start up with the Setting mode (08).
(2) Perform 08-3870 and check the registered Electronic key.
(3) Connect the one-time dongle used for registering the Electronic key to the USB port of the
equipment.
Note:
The one-time dongle to be used is the one for the previous registration of the Electronic key.
(4) Perform 08-3841. The Electronic keys which can be returned to the one-time dongle are
displayed.
(5) Select one and press the [RETURN] button.
Note:
The Electronic key is deleted from the equipment and is stored in the one-time dongle.
(6) After the equipment is replaced, start up with the Setting mode (08).
(7) Connect the one-time dongle to the USB port and perform 08-3840.
(8) Perform the re-registration in the same manner as a regular one.
e-STUDIO5520C/6520C/6530C
REPLACEMENT OF PC BOARDS/HDD
© 2008-2011 TOSHIBA TEC CORPORATION All rights reserved
7 - 36