Quick Stop Active - Lenze i950 Commissioning Manual

16.1.6.6

Quick stop active

This device state is active if quick stop is executed or active.
Only the parameters of the inverter can be changed that do not require an inverter disa-
•
ble.
If the internal holding brake control (0x2820:001) is active in the inverter, the motor brake
•
is closed.
The drive control is active.
•
1 From all states
2 Power section inhibited (pulse inhibit)
3 Power section enabled
Bit pattern in the CiA 402 status word (0x6041)
Bit 15 ... 8 Bit 7
Reserved Warning
(specific) active
X X
X = state is not relevant
The "Enable operation" command stops an active quick stop.
Bit 6 Bit 5
Operation Quick stop DC bus ready
inhibited active for operation
0 0
Configuring the network
Bit 4 Bit 3 Bit 2
Fault active Operation
enabled
X 0
Device profile CiA 402
Device states
Bit 1 Bit 0
Switched on Ready to
switch on
1 1 1
307