Ntp Server Addresses; Diagnostics - Lenze i950 Commissioning Manual

Configure engineering port

Diagnostics

Address Name / setting range / [default setting]
0x2451:003 Engineering port settings: Gateway
0.0.0.0 ... [0.0.0.0] ... 255.255.255.255
0x2451:004 Engineering port settings: DHCP
0 Disabled
1 Enabled
0x245B:001 System time: Time base
0 NTP
1 EtherCAT distributed clock
2 Manual input
0x245B:002 System time: Current time
0 ... [] ... 18446744073709551615 ns
15.2

NTP server addresses

Parameter
Address Name / setting range / [default setting]
0x245A:001 NTP server addresses: Activate NTP server addresses
0 No action/no error
1 Restart with current values
10 In progress
11 Action cancelled
12 Fault
0x245A:002 NTP server addresses: NTP server address 1
0.0.0.0 ... [0.0.0.0] ... 255.255.255.255
0x245A:003 NTP server addresses: NTP server address 2
0.0.0.0 ... [0.0.0.0] ... 255.255.255.255
0x245A:004 NTP server addresses: NTP server address 3
0.0.0.0 ... [0.0.0.0] ... 255.255.255.255
0x245A:005 NTP server addresses: NTP server address 4
0.0.0.0 ... [0.0.0.0] ... 255.255.255.255
15.3 Diagnostics
The network settings can be diagnosed as follows:
Parameter
Address Name / setting range / [default setting]
0x2452:001 Active engineering port settings: IP address
• Read only
0x2452:002 Active engineering port settings: Subnet
• Read only
0x2452:003 Active engineering port settings: Gateway
• Read only
0x2452:005 Active engineering port settings: MAC address
• Read only
290
Info
Setting of the gateway address.
Example:
The setting 276344004 corresponds to the gateway address
196.172.120.16.
• 276344004 = 0x1078ACC4 à 0xC4.0xAC.0x78.0x10 = 196.172.120.16
Use (enable) of the Dynamic Host Configuration Protocol (DHCP).
Info
Info
Display of the active IP address.
Display of the active subnet mask.
Display of the active gateway address.
Display of the MAC-ID.