Device Functions; Optical Device Identification - Lenze i950 Commissioning Manual

17

Device functions

17.1

Optical device identification

For applications including several interconnected inverters it may be difficult to locate a device
that has been connected online. The "Optical device identification" function serves to locate
the inverter by means of blinking LEDs.
Details
In order to start the visual tracking,
click the button in the toolbar of the »EASY Starter«
•
set 0x2021:001 = "Start [1]".
•
After the start, both LEDs "RDY" and "ERR" on the front of the inverter synchronously blink
very fast.
"RDY" LED (blue) "ERR" LED (red)
Both LEDs are blinking in a very rapidly synchro-
nous mode
The blinking duration can be set in
down list field:
Parameter
Address Name / setting range / [default setting]
0x2021:001 Optical tracking: Start detection
0 Stop
1 Start
0x2021:002 Optical tracking: Blinking duration
0 ... [5] ... 6000 s
or
Status/meaning
"Visual tracking" function is active.
0x2021:002 or selected in the »EASY Starter« in the drop-
Info
1 = start optical device identification.
• After the start, the two LEDs "RDY" and "ERR" on the front of the
inverter are blinking with a blinking frequency of 20 Hz for the blink-
ing duration set in 0x2021:002. The setting is then automatically reset
to "0" again.
• If the function is reactivated within the blinking time set, the time is
extended correspondingly.
• A manual reset to "0" makes it possible to stop the function prema-
turely.
Setting of the blinking duration for the visual tracking.
Device functions
Optical device identification
353