Control Settings - Lenze i950 Commissioning Manual

Configuring the "Electronic Gearbox" TA

Control settings

Parameter
Address Name / setting range / [default setting]
0x4000 Application selection
• Setting can only be changed if the inverter is inhibi-
ted.
0 "CiA 402" technology application
10 "Speed Control" technology application
20 "Table Positioning" technology application
40 "Electronic Gearbox" technology applica-
tion
41 "Sync and Correction" technology applica-
tion
50 "Winder Dancer" technology application
51 "Winder Tension" technology application
10000 "User" technology application
7.1 Control settings
General variables such as starting values, reference variables, and signal sources must be
defined before the control system of the technology application is configured.
Settings in "EASY Starter":
Settings tab
•
Technology application parameter dialogue for
•
Application selection
•
40x4000
Relevant parameters of other functions
Address Designation
0x4001 Interface selection
0x5020:007 Application quick stop source
0x5020:008 Source of fault reset
0x5020:014 Master value source
0x5020:030 Source of digital output 1
0x5040:006 Display value 1
92
Info
Default setting
Fieldbus network [0]
FALSE [0]
FALSE [0]
System bus [0]
Ready to switch on [0]
None [0]
Setting range
Selection list
Selection list
Selection list
Selection list
Selection list
Selection list