5.2.5 List Of Warnings - YASKAWA SGD7S-R70A20A023F40B Product Manual

Warning
Warning Name
Number
Preventative Mainte-
A.9b0
nance Warning
*
If using the commands for the MECHATROLINK-III standard servo profile, the warning will automatically be
cleared after the correct command is received.
Note: 1. A warning code is not output unless you set Pn001 to n.1 (Output both alarm codes and warning
codes).
2. Use Pn008 = n.X (Warning Detection Selection) to control warning detection.
However, the following warnings are not affected by the setting of Pn008 = n.X and other parameter
settings are required in addition to Pn008 = n.X.
Warning
A.911
A.923
A.930
A.942
A.94A to A.960 and
A.97A to A.97b
A.971
A.9A0
A.9b0
One of the consumable parts has reached the end of its
service life.
Parameters That Must Be Set to Select Warning Detection
Pn310 = n.X (Vibration Detection Selection)
–
(Not affected by the setting of Pn008 = n.X.)
Pn008 = n.X (Low Battery Voltage Alarm/Warning Selection)
Pn423 = n.X (Speed Ripple Compensation Information Disagreement Warning
Detection Selection)
Pn800=n.X (Warning Check Masks)
Pn008 = n.X (Low Battery Voltage Alarm/Warning Selection)
(Not affected by the setting of Pn008 = n.X.)
Pn00D = n.X (Overtravel Warning Detection Selection)
(Not affected by the setting of Pn008 = n.X.)
Pn00F = n.X (Preventative Maintenance Warning Selection)
5.2 FT41 Specification
Continued from previous page.
Meaning

5.2.5 List of Warnings

Resetting
Required.
5-97
5