YASKAWA SGD7S-R70A20A023F40B Product Manual page 270

Parameter
Default Setting
No.
8F
10000
PnB1E
90
0FFF3F3Fh
PnB20
91
0FFF3F33h
PnB22
92
007F01F0h
PnB24
93
FF0FFEFEh
PnB26
*1.
The enable timing depends on the digit that is changed. Refer to the following section for details.
6.2.1 List of Servo Parameters
6.2.2 List of MECHATROLINK-III Common Parameters
*2.
The parameter setting is enabled after SENS_ON command execution is completed.
*3.
Change the setting when the reference is stopped (i.e., while DEN is set to 1). If you change the setting during
operation, the reference output will be affected.
on page 6-4
on page 6-48
6.2 FT40 Specification
6.2.3 Parameter Recording Table
Continued from previous page.
Name
Speed Coincidence Signal
Detection Width
Servo Command Control
Field Enable/Disable Selec-
tions (read only)
Servo Status Field Enable/
Disable Selections (read
only)
Output Bit Enable/Disable
Selections (read only)
Input Bit Enable/Disable
Selections (read only)
When
Enabled
Immediately
–
–
–
–
6
6-69