YASKAWA SGD7S-R70A20A023F40B Product Manual page 95

Alarm
Alarm Name
Number
Power Supply Line Open
A.F10
Phase
Servomotor Main Circuit
A.F50
Cable Disconnection
FL-1*
FL-2*
FL-3*
System Alarm
FL-4*
FL-5*
FL-6*
Digital Operator Commu-
CPF00
nications Error 1
Digital Operator Commu-
CPF01
nications Error 2
*
These alarms are not stored in the alarm history. They are only displayed on the panel display.
Note: The A.Eb0, A.Eb2 to A.Eb9, and A.EC0 to A.EC2 alarms can occur when a Safety Module is connected.
Refer to the following manual for details.
Σ
AC Servo Drive -V-Series/
No.: SIEP C720829 06)
Alarm Meaning
The voltage was low for more than one second
for phase R, S, or T when the main power supply
was ON.
The Servomotor did not operate or power was
not supplied to the Servomotor even though the
SV_ON (Servo ON) command was input when the
Servomotor was ready to receive it.
An internal program error occurred in the SER-
VOPACK.
Communications were not possible between the
Digital Operator (model: JUSP-OP05A-1-E) and
the SERVOPACK (e.g., a CPU error occurred).
Σ
-V-Series for Large-Capacity Models/
5.1 FT40 Specification
5.1.2 List of Alarms
Continued from previous page.
Servo-
motor
Stop-
ping
Method
Gr.2
Gr.1
–
–
Σ
-7-Series User's Manual Safety Module (Manual
Alarm
Reset
Possi-
ble?
Yes
Yes
No
No
5
5-7