Subaru Legacy 2003 Service Manual page 3374

2) Pry off clip from outer end of boot, and slide boot
toward tie-rod end.
( 1 )
(1) Clip
3) Using standard screwdriver, remove band from
boot.
(1) Band
4) Extend rack approximately 40 mm (1.57 in) out.
Unlock lock wire at lock washer on each side of tie-
rod end using a standard screwdriver.
CAUTION:
Be careful not to scratch rack surface as oil
leaks may result.
STEERING GEARBOX [RHD MODEL]
PS-00290
( 1 )
PS-00291
40 mm (1.57 in)
PS-00292
POWER ASSISTED SYSTEM (POWER STEERING)
5) Using ST, loosen lock nut.
ST 926230000
(1) Lock nut
6) Tighten adjusting screw until it no longer tight-
ens.
(1) Adjusting screw
7) Using a wrench (32 mm width across flats) or ad-
justable wrench, remove tie-rod.
CAUTION:
• Check ball joint for free play, and tie-rod for
bends. Replace if necessary.
• Check dust seals used with tie-rod end ball
joint for damage or deterioration. Replace if
necessary.
(1) Tie-rod
PS-53
SPANNER
ST
( 1 )
( 1 )
( 1 )
PS-00293
PS-00294
PS-00295