Subaru Legacy 2003 Service Manual page 3568

7. Main Harness
A: REMOVAL
1) Turn ignition switch OFF.
2) Disconnect the ground cable from the battery
and wait for at least 20 seconds before starting
work.
3) Remove instrument panel. <Ref. to EI-35, RE-
MOVAL, Instrument Panel Assembly.>
4) Disconnect connector from airbag control mod-
ule.
5) Disconnect front sub sensor connector (blue)
from airbag main harness.
MAIN HARNESS
6) Detach clips from steering support beam, and
remove main harness.
B: INSTALLATION
Install in the reverse order of removal.
C: INSPECTION
Check for the following, and replace damaged
parts with new parts.
• Harness and/or connector is damaged.
AB-00179
AB-00180
AB-15
A
A
A - A
AIRBAG SYSTEM
: ( 1 )
AB-00345