Subaru Legacy 2003 Service Manual page 3379

POWER ASSISTED SYSTEM (POWER STEERING)
22) While fixing 2-surface width, pull out oil seal by
rotating nut.
( 1 )
(1) 2-surface width
(2) Nut
D: ASSEMBLY
Specified steering grease:
VALIANT GREASE M2 (Part No.
003608001)
1) Apply grease inside and outside of oil seal and
press in using ST and press.
ST 34199AE130 GEARBOX OIL SEAL IN-
STALLER
CAUTION:
Pay attention to oil seal direction, and attaching
position.
Be careful no to scratch gearbox inside sur-
face.
ST
(1) Oil seal
STEERING GEARBOX [RHD MODEL]
( 2 )
PS-00309
( 1 )
PS-00310
2) Attach steering body to ST as shown. Apply a
coat of grease to needle bearing.
ST 926200000
CAUTION:
• Use a ST to support steering body.
• Ensure that needle bearing is free from de-
fects. If it is faulty, replace steering body with a
new one.
NOTE:
If steering body is removed from vehicle, be sure to
remove rust and clean.
(1) Steering body
3) Using ST·B and ST·C, attach oil seal to ST·A. In-
sert ST·A into rack from gear side. Remove oil seal
from ST·A when it approaches piston and remove
STs from rack.
ST 927490000
NOTE:
Face oil seal in the direction shown in figure.
ST•C
(1) Oil seal
(2) Rack
PS-58
STAND
ST
( 1 )
INSTALLER; A·B·C
ST•B ST•A
( 1 )
ST•A
( 2 )
PS-00311
PS-00312