Subaru Legacy 2003 Service Manual page 3364

5) Fit pinion and valve assembly into valve hous-
ing.
NOTE:
Apply specified power steering fluid to outer diam-
eter surface of input shaft and outer surface of
valve body seal ring, and pay special attention not
to damage seal when inserting pinion and valve as-
sembly.
6) Secure valve assembly to ST1 and ST2.
7) Put ST3 over pinion, and insert oil seal, then
force-fit oil seal into housing using ST4.
ST1 926370000 INSTALLER A
ST2 927630000 STAND BASE
ST3 926360000 INSTALLER A
ST4 927620000 INSTALLER B
(1) Oil seal
NOTE:
• Apply specified power steering fluid to oil seal
and ST3, being careful not to damage oil seal lip.
• Push oil seal until ST3 contacts housing end
face.
8) Remove ST3, and fit backing washer.
STEERING GEARBOX [LHD MODEL]
ST3
ST4
( 1 )
ST1
ST2
PS-00172
PS-43
POWER ASSISTED SYSTEM (POWER STEERING)
9) Force-fit ball bearing using ST3.
ST1 926370000 INSTALLER A
ST2 34099FA100 STAND BASE
ST3 927640000 INSTALLER B
( 1 )
( 2 )
(1) Ball bearing
(2) Backing washer
NOTE:
Be careful not to tilt ball bearing during installation.
10) Install snap ring using snap ring pliers.
NOTE:
Rotate snap ring to check for proper installation.
11) Apply genuine grease to pinion gear and bear-
ing of valve assembly.
12) Apply specified grease to dust cover.
13) Install dust cover on valve assembly.
ST3
ST1
ST2
PS-00173
PS-00165
PS-00282