Subaru Legacy 2003 Service Manual page 3404

Tightening torque:
37.3 N·m (3.8 kgf-m, 27.5 ft-lb)
2) Tighten bolts which install power steering pump
bracket.
Tightening torque:
33.3 N·m (3.4 kgf-m, 24.5 ft-lb)
3) Interconnect pressure hose and suction hose.
Tightening torque:
Eye bolt
39.2 N·m (4 kgf-m, 28.9 ft-lb)
CAUTION:
If a hose is twisted at this step, the hose may
come into contact with some other parts.
( 1 )
( 2 )
(1) Suction hose
(2) Pressure hose
4) Connect connector to power steering oil pres-
sure switch.
5) Install tensioner adjuster.
6) Install V-belt.
OIL PUMP
POWER ASSISTED SYSTEM (POWER STEERING)
7) Install pulley belt cover.
8) Connect ground terminal of battery.
9) Feed the specified power steering fluid. <Ref. to
PS-92, Power Steering Fluid.>
CAUTION:
Never start the engine before feeding the fluid;
otherwise vane pump might be seized up.
C: DISASSEMBLY
NOTE:
Oil pump for 3.0 L and Turbo model cannot be dis-
assembled. If the oil pump is malfunctioning, re-
PS-00338
place the oil pump as an assembly.
1) Using ST, place oil pump in a vise and remove
four bolts which secure rear cover.
ST 34199AE020 ATTACHMENT
2) Remove pressure plate.
PS-00232
3) Using a screwdriver, pry retaining ring off.
CAUTION:
Do not remove cam ring, rotor, etc.
PS-00228
4) Install pressure plate.
PS-83
ST
PS-00233
PS-00234
PS-00235