Subaru Legacy 2003 Service Manual page 3401

POWER ASSISTED SYSTEM (POWER STEERING)
10) Disassemble oil pump and bracket by inserting
a screwdriver as shown in the figure.
2. 3.0 L AND TURBO MODEL
1) Remove ground cable from battery.
2) Remove pulley belt cover.
3) Remove V-belt.
4) Disconnect connector from power steering pres-
sure switch.
5) Remove tensioner adjuster.
6) Disconnect pressure hose and suction hose
from oil pump.
CAUTION:
• Do not allow fluid from the hose end to come
into contact with pulley belt.
• To prevent foreign matter from entering the
hose, cover the open ends of them with a clean
cloth.
( 1 )
( 2 )
(1) Pressure hose
(2) Suction hose
7) Remove bolts, which install power steering
pump bracket.
OIL PUMP
8) Place oil pump bracket in a vise, remove two
bolts from the front side of oil pump.
CAUTION:
Do not place oil pump bracket directly in the
vise; use soft pads and hold oil pump lightly to
protect the pump.
PS-00129
9) Remove bolt from the rear side of oil pump.
10) Remove oil pump from bracket.
PS-00228
PS-80
PS-00229
PS-00338