Subaru Legacy 2003 Service Manual page 3403

POWER ASSISTED SYSTEM (POWER STEERING)
4) Interconnect pipes C and suction hose.
Tightening torque:
Joint nut
39.2 N·m (4 kgf-m, 28.9 ft-lb)
CAUTION:
If a hose is twisted at this step, the hose may
come into contact with some other parts.
(1) Suction hose
(2) Pipe C
5) Connect connector to power steering oil pres-
sure switch.
6) Install pulley belt to oil pump.
7) Check pulley belt tension. <Ref. to ME(H4SO)-
41, V-belt.> and <Ref. to ME(H6DO)-28, V-belt.>
8) Tighten lock bolt.
Tightening torque:
24.5 N·m (2.5 kgf-m, 18.1 ft-lb)
9) Tighten bolt belt tension.
Tightening torque:
8 N·m (0.8 kgf-m, 5.8 ft-lb)
10) Install pulley belt cover bracket.
11) Connect ground terminal of battery.
12) Feed the specified power steering fluid <Ref. to
PS-92, Power Steering Fluid.>
CAUTION:
Never start the engine before feeding the fluid;
otherwise vane pump might be seized up.
OIL PUMP
2. 3.0 L AND TURBO MODEL
1) Install oil pump to bracket.
CAUTION:
Do not place oil pump bracket directly in the
vise; use soft pads and hold oil pump lightly to
protect the pump.
( 1 )
( 2 )
PS-00225
Tightening torque:
PS-82
(1) Place oil pump bracket in a vise. Tighten
bushing using a 12.7 mm (1/2") type 14 and 21-
mm box wrench until it is in contact with oil pump
mounting surface.
( 5 )
( 3 )
( 4 )
(1) Bushing
(2) Nut
(3) 21 mm
(4) 14 mm
(5) Bolt
(2) Tighten bolt which installs oil pump to brack-
et.
15.7 N·m (1.6 kgf-m, 11.6 ft-lb)
( 1 )
( 2 )
PS-00135
PS-00229