Subaru Legacy 2003 Service Manual page 3385

POWER ASSISTED SYSTEM (POWER STEERING)
28) Install a new boot band. Using band clamp pli-
ers, caulk the boot band to make clearance of
caulking part 2 mm (0.079 in) or less.
(1) Boot band
(2) 2 mm (0.079 in) or less
29) Fix the boot end with clip (small).
( 1 )
(1) Clip
(2) 2 mm (0.079 in) or less
30) After installing, check the boot end is posi-
tioned into groove on tie-rod.
STEERING GEARBOX [RHD MODEL]
(1)
(2)
PS-00195
PS-00096
31) If the tie-rod end was removed, screw in the
lock nut and tie-rod end to screwed portion of tie-
rod, and then tighten the lock nut temporarily in a
position as shown in the figure.
Installed tie-rod length: L
15 mm (0.59 in)
PS-64
L
PS-00097